Author Topic: easy way to adjust for rotor speed  (Read 1164 times)

0 Members and 1 Guest are viewing this topic.

MrPerfect.

  • Moderator
  • Great Contributor
  • *****
  • Posts: 978
  • Thanked: 542 times
easy way to adjust for rotor speed
« on: July 25, 2016, 01:34:23 PM »
 If we know time that ball will take from our prediction moment to drop, we may up ply same time for rotor in the beginning of the spin.  How it's done?
 Look where zero is, start time... at the end of the time look wich number is at the place where zero was. Distance between zero and number we observe at the end of time upplied will be indicator of offset we need to add to our visual key.
 If we use half time , we need to multiply that distance by 2.... ets


 

MrPerfect.

  • Moderator
  • Great Contributor
  • *****
  • Posts: 978
  • Thanked: 542 times
Re: easy way to adjust for rotor speed
« Reply #1 on: July 25, 2016, 09:46:03 PM »
Example...
 Let's say we predict 10 seconds till end.
 We upply same 10 seconds to rotor and see number 6 ( ball cw). We hawe to add 10 pokets to our visual key.
 If we use 5 seconds only to the rotor and see same number 6 , we have to add 20 pokets to our visual key....  You can use any time for rotor and make a simple circular diagram on casino card, where number observed will correspond offset needed to upply.
« Last Edit: September 02, 2016, 11:26:34 AM by MrPerfect. »
 
The following users thanked this post: december

MrPerfect.

  • Moderator
  • Great Contributor
  • *****
  • Posts: 978
  • Thanked: 542 times
Re: easy way to adjust for rotor speed
« Reply #2 on: September 02, 2016, 11:29:29 AM »
Here is example of such a "sircular diagram ".
 This card show offsets needed to upply for our visual key to adjust for rotor speed ( when half of total expected ball's time is used).
 

MrPerfect.

  • Moderator
  • Great Contributor
  • *****
  • Posts: 978
  • Thanked: 542 times
Re: easy way to adjust for rotor speed
« Reply #3 on: September 03, 2016, 12:19:54 PM »
    Some posts have been moved to the new topic " bias and method tolk...." as not related to the subject of original tread.